Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-09-2002, 10:33 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Metairie, La. USA
Posts: 132
|
LCA's and springs
I just finished installing my MM adjustable LCA's. The MM instructions say that the lower pigtail should face the rear of the vehicle. That's the way that I installed them. I just got finished reading another article that said they should be facing the front of the car. Now I am really confused..........HELP!!!
__________________
Engine: 1990 5.8 / Edelbrock Performer set-up MSD ignition Suspension: Maximum Motorsports Caster-Camber Plates / Maximum Motorsports adjustable lower control arms / FRPP heavy duty upper control arms / Tokico Illumina Shocks and Struts / Ground Pounder Coil Over conversion kit front / Steeda cross brace sub-frame connectors / Drivetrain: Tremec 3550 trans / Steeda Tri-Ax shifter / Spec Stage II clutch and pressure plate / Spec aluminum flywheel / 5.8 in the hole |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Looking for good rear LCA's... | jonnyk | Corner Carvers Delight | 2 | 11-28-2001 01:48 PM |
| What's next? Want more neutral handling... | Fox89GT | Corner Carvers Delight | 2 | 02-06-2001 12:43 PM |
| Suspension Opinions-Long | 95Convert | Windsor Power | 3 | 01-28-2001 03:07 PM |