MustangWorks.com : Ford Forums - View Single Post - Problem after distributor install

I'd try putting the timing at 10 degrees if all of the wires are good and in the right order. 15 is a bit high. Also, check the plug gap and make sure no plugs are fowled or anything.

__________________
Michael Black
QuantumMotorsports
Norman, OK

1984 LX Hatch
306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat.
Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites

11-06-2003, 09:38 PM	#5
QuantumMotorsports Registered Member Join Date: Jul 2000 Location: Norman, Oklahoma, USA Posts: 597	I'd try putting the timing at 10 degrees if all of the wires are good and in the right order. 15 is a bit high. Also, check the plug gap and make sure no plugs are fowled or anything. __________________ Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites