Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-05-2004, 12:52 PM
|
#1 |
|
Registered Member
Join Date: Jan 2003
Location: Palm Bay, FL
Posts: 432
|
Proper pushrod length?
I was using stock pushrods with about a 6.25 in. length. I was using them with aluminum rocker arms, OEM lifters, and guideplates. Needless to say, the guideplates ate the pushrods up. I need to buy new pushrods, but the only ones I find in the stock length are non-hardened. I'm gonna buy hardened chromemoly, and I found a set for use with, basically, what I'm running, but the length was 6.375. Will those be ok?
__________________
'91 Mustang GT 5.0 AOD Daily Driver Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI 13.73 at 103.8, ~2.2 60' |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pushrod Length help | BLACK85GT | Windsor Power | 3 | 02-04-2004 10:27 AM |
| pushrod length? which one?? | DemonGT | Windsor Power | 0 | 07-06-2003 03:51 AM |
| AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |
| pushrod length question/adjusting valve train preload | 84LX89GT | Windsor Power | 4 | 01-03-2003 03:59 PM |
| Stock Pushrod Length | StreetRacin89Stang | Windsor Power | 4 | 04-17-2001 04:12 PM |