Re: Pulled codes - now CEL is on???
Update - persistance pays off ( or it was a couple of beers that did it...)
The code reader manual also mentioned corrosion that can affect the connectors. Mine didn't look too good so I cleaned the connector leads with a small piece of emory cloth and brake cleaner. Then as I was checking the wires through the plug I found that the continuity was shared between the two wires - so who knows what it was doing when connected to the reader. So I just cut the wires to the plug and wired it straight to the reader.
The test ran and I finally got my long awaited codes. Looks like I have a problem with the Canister Purge Solenoid - whatever that is - and an O2 sensor or circuit problem.
I can handle the O2 sensors. Too bad I don't have OBDII since I think that will tell you which one is.
Anyone know about this Canister thing...?
__________________
Spec Service (UHP), BFG G-Force KDW's, Turbo Coupe 3.55 rear w/disks, 73mm calipers, Stg 1 Twisted Wedges, TFS Street Intake, 70mm TB, E cam, Crane 1.7's, Aeromotive FPR, BBK 1 5/8 shorties, elec fan, FMS Al Radiator, Moroso Wires, Kenne Bell Ramair, March pulleys, Race Magnums, 190 lph Walbro, FMS Al Dshaft, D/S loop, MM 4point rollbar, FMS C spngs, strut tower brace, Tokico Illuminas, Prothane bushings, MM Lwr Conrol Arms, KB welded subs, Cervini Mach 1 hood/valence/side skirts/wing/airdam.
|