MustangWorks.com : Ford Forums

MustangWorks.com : Ford Forums (http://forums.mustangworks.com/index.php)
-   Windsor Power (http://forums.mustangworks.com/forumdisplay.php?f=8)
-   -   pulled the codes off my eec iv (http://forums.mustangworks.com/showthread.php?t=41133)

84gt347 01-20-2004 07:01 PM

pulled the codes off my eec iv
 
I have a 92 lincoln mkv11, i converted it to mass air a looong time ago. I have a check engine light and the car is running rich as hell. I pulled the codes. 15 power interrupt, rom failed coil 1 primary circuit failed. 24 evp,pfe voltage too low, 85 cannister purge solinoid failed and 95 fuel pump secondary circuit fault. Is my computer screwed up?

Simi Stang 01-21-2004 12:54 PM

charcoal canister
 
I don't think your computer is screwed up. Those sound like legitimate codes. When you did the mass-air conv. did you install all the smog equipment on the '92 Lincoln? Code 85 - canister purge solenoid failure is referring to the charcoal canister. I pulled this code a few weeks ago...but I have my smog equipment removed...so that solenoid isn't even in my engine compartment any longer. So if you do still have your charcoal canister, try replacing the sensor/solenoid on top of it. As for the other codes...I have no info. for you...sorry.

84gt347 01-21-2004 03:06 PM

Re: charcoal canister
 
Quote:

Originally posted by Simi Stang
I don't think your computer is screwed up. Those sound like legitimate codes. When you did the mass-air conv. did you install all the smog equipment on the '92 Lincoln? Code 85 - canister purge solenoid failure is referring to the charcoal canister. I pulled this code a few weeks ago...but I have my smog equipment removed...so that solenoid isn't even in my engine compartment any longer. So if you do still have your charcoal canister, try replacing the sensor/solenoid on top of it. As for the other codes...I have no info. for you...sorry.
i removed my smog equipment also. I'm not too worried about that code, mostly the 15. Thanks though

Hethj7 01-23-2004 01:10 PM

It has been a while since I dealt with these codes, so I may not be entirely correct, but if I remember right, the code 94 means your fuel pump relay is going bad. It is a cheap part and easy to replace though, so you may try that to clear that code.

Sorry, I don't have any info on code 15.

Hethj7 01-23-2004 01:15 PM

I just did some checking here and it was actually code 96 that I was thinking of, although they both give a similar description, "Fuel pump secondary circuit fault, high speed fuel pump relay open". Maybe your code could be the relay also
:confused: .

84gt347 01-23-2004 05:25 PM

im gonna check the fuel pump relay and the safty cut off switch also. Thanks


All times are GMT -5. The time now is 09:26 AM.