View Single Post
Old 09-01-2002, 12:59 AM   #1
Rebel79
News Editor
 
Rebel79's Avatar
 
Join Date: Apr 1999
Location: Concord, CA
Posts: 2,101
Default Pulled intake and swapped fuel rails now getting codes.

Ok here's the deal.... I was rear ended a couple months ago and it knocked out my intank pump. I was able to get it working again by banking on the tank, but after that I was not getting increased Fuel Pressure under boost. So I rebuilt my FMU and screwed it up, which blasted out my fuel rail and FPR.

So I pulled the intake and swapped out the fuel rails for another stock set. I had a few problems getting the intake on, and getting the EGR tube to line up (never had that problem before).

Anyways I started the car and it was running fine, but on a small road test the Check Engine light came on. Here are the codes I pulled:

KOEO:
511 - ROM failed. Not sure if this is because of have a JMS chip or not.
322 - Lack of continuous EGR flow (Continuous Memory)

KOER:
314 - Air System Inoperative on Bank 1.
311 - Air System Inoperative on Bank 2.
322 - Lack of continuous EGR flow (Continuous Memory)

What does all this mean, and how can I get rid of them? I would assume its safe to putt around town for the time being right?
__________________
Scott Halihan, News Editor
The MustangWorks Magazine
1994 Supercharged Mustang Cobra
Rebel Racing. Home of Bay Area Mustangs
Rebel79 is offline   Reply With Quote