Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-27-2005, 10:54 AM
|
#1 |
|
Registered Member
Join Date: Jul 2000
Location: Rochester
Posts: 323
|
pushrod length
I'm planning on upgrading to a new set of 1.7 rocker arms and figured I might as well replace the stock pushrods. The problem is that I'm running into different size pushrods available for the roller cams. Comp Cams has a set that are 6.250, Ford Racing has a set that are 6.272, and Crane has a set that's 6.258 inches long. I would think that the Ford racing rods would give the stock cam with 1.7 rockers would be a good combo with my Comp Cams valve springs. But I'm worried about too much valve lift, and piston to valve clearence..
If anyone has any input I'd greatly appreciate it.... Thanks
__________________
95 GT convertable, ported+polished GT40 heads, port matched upper and lower Cobra intake manifold, Flowthech headers, Catco hi-flow h-pipe with 2 hi-flow cats, Mac true fit catback exhaust, 3.73 gears, underdrive pullies, Edelbrock 70mm throttle body, Mac cold air intake, FMS 24lb injectors, Granatelli 75mm mass air |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pushrod Length: 351 heads on 302 | lucheski | Windsor Power | 4 | 06-17-2005 06:34 PM |
| Pushrod Length help | BLACK85GT | Windsor Power | 3 | 02-04-2004 10:27 AM |
| pushrod length? which one?? | DemonGT | Windsor Power | 0 | 07-06-2003 03:51 AM |
| AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |
| Stock Pushrod Length | StreetRacin89Stang | Windsor Power | 4 | 04-17-2001 04:12 PM |