© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-02-2004, 04:40 PM | #1 |
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
Pushrod Length help
I am going to be putting my engine together and need the proper procedure for checking pushrod length. I have a pushrod length checker and I need to find the correct pushrods for my new heads etc. My setup is alum. holley heads with pedestal mount scorpion roller rockers. It is a non roller block. Is there a source I can go to for step by step instructions. I cant find it in the haynes manual.
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Proper pushrod length? | Nixon1 | Windsor Power | 3 | 02-05-2004 02:36 PM |
pushrod length? which one?? | DemonGT | Windsor Power | 0 | 07-06-2003 03:51 AM |
AFR 165 pushrod length question. | JaxMustang50 | Windsor Power | 2 | 04-13-2003 11:39 PM |
pushrod length question/adjusting valve train preload | 84LX89GT | Windsor Power | 4 | 01-03-2003 03:59 PM |
Stock Pushrod Length | StreetRacin89Stang | Windsor Power | 4 | 04-17-2001 04:12 PM |