Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-02-2001, 05:51 PM
|
#1 |
|
Registered Member
Join Date: Dec 1998
Location: FLINT/ MICH
Posts: 96
|
pushrod lenght, tfs high ports
need a pushrod lenght,or pt# for 5/16" pushrods for a e4 84 non roller a-4 block running a hydralic flat tappet camshaft,
w/ adjustable 1.7 rockers, non -milled iron tfs high port heads thanks, LX |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| going turbocharged which cubic inch motor to build | Mustangboy89 | Windsor Power | 24 | 07-07-2003 12:45 AM |
| TFS High Ports and Long Tubes | HORSEMEN RACING | Windsor Power | 3 | 07-16-2002 12:57 PM |
| GT-40 lower intake question (small ports) | Dark_5.0 | Windsor Power | 1 | 01-28-2002 08:07 PM |