1.7 ROCKERS WITH FLAT CAM

foxandfoe · 07-04-2001, 12:19 AM

WOULD IT BE A GOOD IDEA TO USE ROLLER ROCKERS
WITH A FLAT TAPPET HYDRAULIC CAM seen adds
for them that have said for roller cams only
cam specs 214-224 i-e .474-.496

sweet88coupe · 07-04-2001, 04:13 PM

if your running the factory shortblock all but the camshaft then go ahead and use the roller rockers, I don't think that the ratio would make much of a difference because the lift is not much.

07-04-2001, 12:19 AM	#1
foxandfoe Registered Member Join Date: Jun 2001 Location: new castle pa Posts: 32	1.7 ROCKERS WITH FLAT CAM WOULD IT BE A GOOD IDEA TO USE ROLLER ROCKERS WITH A FLAT TAPPET HYDRAULIC CAM seen adds for them that have said for roller cams only cam specs 214-224 i-e .474-.496

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dont use 1.7 rockers with stock heads?	Coupe5oh	Windsor Power	10	11-28-2015 12:36 PM
Rail Rockers on 289 Small Block Heads	sleeperstang	Classic Mustangs	16	05-11-2003 11:34 PM
Roller rockers and which cam??'s	Coupe Devil	Windsor Power	5	12-15-2002 12:07 PM
Roller Rockers, bad?	HiFlow5 0	Windsor Power	1	04-14-2002 01:35 PM
reg rockers or roller rockers??	Chevysucks	Windsor Power	1	12-05-2001 08:17 PM

07-04-2001, 04:13 PM	#2
sweet88coupe Registered Member Join Date: Jul 2001 Location: westville, fl 32464 Posts: 10	if your running the factory shortblock all but the camshaft then go ahead and use the roller rockers, I don't think that the ratio would make much of a difference because the lift is not much.