Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-08-2003, 03:15 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
Rocker bolts
 I have been working on my friends 1995 mustang and the we are attempting to tighten the rocker arm bolts. The book only says - Step 1: 45 ft lbs - Step 2: 19. That's all it says. I understand the 45lbs, but what is the 19 for. It does not say what to do with the 19. Do I need to loosen the bolt and retighten to 19 lbs or is it trying to say to tighten to 45 and turn an add. 19 degrees. It just is not specific, any help appreciated.
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Use loc-tite on rocker arm bolts? | skiwesser | Windsor Power | 1 | 04-07-2003 11:57 PM |
| Only 3 bolts holding fan to water pump? | Hethj7 | Windsor Power | 5 | 03-27-2003 03:26 PM |
| Pressure plate bolts | WhiteLX | Windsor Power | 1 | 09-15-2002 06:50 AM |
| loctite rocker arm bolts? | matt cook | Windsor Power | 1 | 03-27-2002 12:40 AM |
| Anyone use locktite on rocker bolts? | jeb | Windsor Power | 3 | 05-31-2001 01:09 AM |