![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Jul 2000
Location: Rochester
Posts: 323
|
![]() This may sound like a dumb question, but nobody has given me a straight answer yet....
How important is it to set each cylinder to top dead center when changing out rocker arms. I've done numerous head swaps before and all I had to do was set cylinder one to tdc and go from there. Every manual says to set each cylinder at tdc, but I don't know why, and I'm woundering if you really have to do it if you're just swapping rocker arms.
__________________
95 GT convertable, ported+polished GT40 heads, port matched upper and lower Cobra intake manifold, Flowthech headers, Catco hi-flow h-pipe with 2 hi-flow cats, Mac true fit catback exhaust, 3.73 gears, underdrive pullies, Edelbrock 70mm throttle body, Mac cold air intake, FMS 24lb injectors, Granatelli 75mm mass air |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Roller rocker question? | HiFlow5 0 | Windsor Power | 1 | 05-18-2004 12:07 PM |
Help! - Pedistal Rocker Question | Bobasaurus | Windsor Power | 5 | 12-08-2002 10:56 AM |
Rocker Question. | Mopar1 | Windsor Power | 1 | 09-20-2002 09:02 PM |
Rocker Arms Question | Falcons Talon | Windsor Power | 1 | 08-11-2002 11:27 PM |
Rocker Panel Moldings Question | Matt683 | Classic Mustangs | 4 | 01-05-2001 02:46 PM |