MustangWorks.com : Ford Forums - View Single Post

429mustang · 09-11-2003, 09:05 PM

Mine are a mess, they sound like sh*t and I can't get them to run quiet. They're stud mount roller rockers (proform/blue 1.5 ratio) and I just rebuilt the motor with a new set of Crane blazer pushrods, I'm also running a high volume oil pump which keeps the pressure up plenty even when it's hot. I've tried adjusting them with 1/2 turn then I tried a little more, then 3/4 turn and they almost seem worse. I'd think they'd get quieter and eventually the motor would run crappy if they were too tight, but they wouldn't be noisey. Any ideas??

09-11-2003, 09:05 PM	#4
429mustang Registered Member Join Date: May 2001 Location: westerville, OH USA Posts: 618	Mine are a mess, they sound like sh*t and I can't get them to run quiet. They're stud mount roller rockers (proform/blue 1.5 ratio) and I just rebuilt the motor with a new set of Crane blazer pushrods, I'm also running a high volume oil pump which keeps the pressure up plenty even when it's hot. I've tried adjusting them with 1/2 turn then I tried a little more, then 3/4 turn and they almost seem worse. I'd think they'd get quieter and eventually the motor would run crappy if they were too tight, but they wouldn't be noisey. Any ideas?? __________________ 1990 Notchback: BBK Ceramic Coated Full length headers, Dr. Gas 3"- 2 1/2" x-pipe, Flowmaster 40's/turndowns.