roll cage install...
 

Got my comp engineering roll cage kit today and install is going Sun.

Doesn't look too hard (I hope) You guys got any advice before I start?

prep and paint before it goes in. Dont bolt it, weld it in..

I have a 6-pt rollcage in my stang, so i can offer advice. Mine is bolted and welded - thats the best combo. Also, if u can, get the bars that tie into the front floorboards to sway on a hinge so u can get in/out easily. What style mustang do u have. If it's SN-95 i can offer more advice.

------------------
Blueneonman - '95 5.0L Mustang GT Convertible | K&N Drop-in | FMS 9mm Wires | Hi-Flow Cats | Flowmaster 2 Chambers | Subframes | 6-pt Rollcage | 14deg Timing | Coolest Neon Lighting on a Mustang EVER!

well, prepped and painted it today. Removed rear seat, panels, and all kinds of other stuff. Did a mock up and it looks like it is going to fit real well.

tommorrow it gets welded in...hopefully!



------------------
My Mustang
91 LX Conv. 52,000 orig mi. Hurst shifter,King Cobra clutch, 3.55 grs, NOS 150 dry kit, MSD 6al, MSD timing control, malory coil, pullies, fms adj fuel reg, BBK 70mm tb, Pro-m 75mm maf, battery in trunk, JBA shorties, JBA subs, JBA strut tower brc, dynomax "super turbo" 2 1/2 exhaust, FMS billit distrib, Hotchkis lower cntrl arms, MAC Fenderwell cold air kit, off road h pipe.

hey, blueneonman1...
how hard was it to install in your vert?
did you have to remove the carpet too...
I plan on doing mine this spring on my 95 vert

------------------
95 GT convertable, 3.73 gears, bbk off road h-pipe, march underdrive pullies, Saleen wires, custom made cold air induction,
Future mods (Winter/Spring break)
Cobra intake w/ 65mm tb
GT40 heads, flowtech headers, Lunatti cam 230 duration 488 lift