MustangWorks.com : Ford Forums - View Single Post - Scanning Software for EEC-IV

stangsrule · 01-07-2003, 01:38 PM

I am using the TwEECer RT and really like it. You can find it at:http://www.tweecer.com/ and if you want to do a little more reading on it look here:http://tweecer.oplnk.net/ It is probably more money than you are looking at now, but with this not only can you data log with it but you can go in and make changes to ANYTHING and EVERYTHING the computer controls. It is like a custom chip only better and you can change the stuff anytime you want AND store 4 programs to switch between on the fly! Good luck with whatever you decide on.

01-07-2003, 01:38 PM	#2
stangsrule Registered Member Join Date: May 1999 Location: Indiana Posts: 512	I am using the TwEECer RT and really like it. You can find it at:http://www.tweecer.com/ and if you want to do a little more reading on it look here:http://tweecer.oplnk.net/ It is probably more money than you are looking at now, but with this not only can you data log with it but you can go in and make changes to ANYTHING and EVERYTHING the computer controls. It is like a custom chip only better and you can change the stuff anytime you want AND store 4 programs to switch between on the fly! Good luck with whatever you decide on. __________________ 92GT Lowered with Ebiach's and Koni's, Kenny Brown subframe connectors, lower G-brace and jacking rails. BBK upper and lower control arms, polyurethane bushings all around and Ken Bell blower, ram-air, 80mm mass air, SMC Alky Injection kit, J&S Knock Gaurd, TwEECer RT and a bunch of other stuff!