Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-20-2001, 01:14 PM
|
#1 |
|
The Photoshop Guru
Join Date: Feb 2001
Location: Mecca, Indiana
Posts: 1,419
|
Shaved heads - Shimming required?
I am installing some ported stock ET7E's on my 5.0 which have been shaved .030. I just ordered some Omega 1.6 roller rockers as well and a set of springs to go with my Trick Flow Stage 1 cam.
My question is, do I need to shim the rockers since the heads have been shaved? If so, where do I get the shims? Also, is there anything else I need to do other than check my piston to valve clearance that I may be unaware of? Thanks. ------------------ Indiana Stangers Association Buy your parts here |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| GT-40 heads | 5.0 Pony | Windsor Power | 1 | 09-10-2002 10:26 PM |
| val springs in stock 97 heads , quesion ? | southernstang97 | Modular Madness | 0 | 07-16-2002 11:52 AM |
| What kind of Windsor heads? | vetteeatr | Windsor Power | 11 | 10-28-2001 03:43 AM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |