MustangWorks.com : Ford Forums - View Single Post - Should I put in a cam when I rebuild motor?

Unit 5302 · 07-11-2005, 06:27 PM

The cam is a 2000-6000rpm cam for the 351W or 302HO according to the Holley website.

51027LUN

.496/.502
218/224
276/281

2000-6000rpm. Application Hot street or Pro Street. The HO cam is a good grind and you're not going to be picking up much power with the E7's, while I expect you'll lose quite a bit of low end torque. The cam favors the exhaust side WAY too much. With an N/A setup on E7s, I see no reason to favor the exhaust.

07-11-2005, 06:27 PM	#10
Unit 5302 Registered Member Join Date: May 1999 Posts: 5,246	Re: Should I put in a cam when I rebuild motor? The cam is a 2000-6000rpm cam for the 351W or 302HO according to the Holley website. 51027LUN .496/.502 218/224 276/281 2000-6000rpm. Application Hot street or Pro Street. The HO cam is a good grind and you're not going to be picking up much power with the E7's, while I expect you'll lose quite a bit of low end torque. The cam favors the exhaust side WAY too much. With an N/A setup on E7s, I see no reason to favor the exhaust.