MustangWorks.com : Ford Forums - View Single Post

avbcon12 · 02-06-2002, 09:48 PM

can i remove the tube that goes from the oil filler neck to the throttle body? well, i know i can but what is the best way to do this?

the reason i am asking is because i just bought a used 65mm throttle body and it does not have the fitting to connect that tube. it is just blocked off. i was going to drill the hole and then everything would go back together stock.

what would or could result in removing it?

i am going to put 1.7RR on so i have to remove the baffles in the valve cover. if that helps.

thanks,
adam

02-06-2002, 09:48 PM	#1
avbcon12 Registered Member Join Date: Jul 2001 Location: West Bloomfield, MI Posts: 391	can i do this without problems? can i remove the tube that goes from the oil filler neck to the throttle body? well, i know i can but what is the best way to do this? the reason i am asking is because i just bought a used 65mm throttle body and it does not have the fitting to connect that tube. it is just blocked off. i was going to drill the hole and then everything would go back together stock. what would or could result in removing it? i am going to put 1.7RR on so i have to remove the baffles in the valve cover. if that helps. thanks, adam __________________ 90 GT black/ grey leather ported GT-40 heads w/ 1.7RR, Cobra intake w/ ported lower, 24# injectors, 190LPH pump, 75mm Pro-M MAF, 65mm TB, K&N panel, BBK long tubes, Off road H-pipe, 2 ch. Flowmaster, Black magic fan, Kirban FPR, 180 deg. T-stat, 3.73's, Steeda Tri-Ax, 130 amp alt. Accell 8.8 race wires/cap/rotor, motorcraft plugs, Factory Five suspension, etc etc etc.... http://avbcon12.stangnet.com