MustangWorks.com : Ford Forums - View Single Post - DONE: Think I can break into 13s? (maybe mid 13s?!?)

Sonics2042 · 03-24-2002, 01:56 PM

What is this Lentech Street Terminator VB?

Also, this is what I just ran:
15.02 @ 92.83 mph
60' ~ 2.3

This is with:
3.55 gears
8* timing
MAC Cat-Back
New Mass Air Flow Sensor
MAC Cold Air Intake

Next time it will be:
3.73 Gears
15* timing
MAC Cat-Back
New Mass Air Flow
MAC Cold Air Intake
BBK Headers
Cobra Intake Manifold (Upper and Lower)
E303 Cam
Nitto Drad Radials
I think that is it.
(and MAYBE a Lentech Street Terminator VB...whenever I find out what it is

)

LATE this summer I MIGHT do heads. Hoping for the best out of this combination. Any ideas on what I should run on this (stock heads).

Thanks,
DoranW

03-24-2002, 01:56 PM	#17
Sonics2042 Registered Member Join Date: Jul 2001 Location: Seattle, WA Posts: 381	What is this Lentech Street Terminator VB? Also, this is what I just ran: 15.02 @ 92.83 mph 60' ~ 2.3 This is with: 3.55 gears 8* timing MAC Cat-Back New Mass Air Flow Sensor MAC Cold Air Intake Next time it will be: 3.73 Gears 15* timing MAC Cat-Back New Mass Air Flow MAC Cold Air Intake BBK Headers Cobra Intake Manifold (Upper and Lower) E303 Cam Nitto Drad Radials I think that is it. (and MAYBE a Lentech Street Terminator VB...whenever I find out what it is ) LATE this summer I MIGHT do heads. Hoping for the best out of this combination. Any ideas on what I should run on this (stock heads). Thanks, DoranW __________________ What I have: 1990 Red Mustang 5.0 LX: [BBK X-Pipe]-[MAC Cat-Back Exhaust] [MAC Cold Air Intake]-[BBK Equal Shorties] [3.55 Gears]-[Cobra Intake Manifold (Upper and Lower] [E-303 Cam]-[Granetelli Mass Air Flow Sensor] [Front and rear sway bars]-[New black carpet and seats.] [Adjustable Fuel Regulator]-[T5 Conversion w/ K. Cobra Clutch/Hurst STS] [Cobra Throttle Body]-[130A Alt. Conversion] Thinking about: Aftermarket Heads! Vortech A-Trim