MustangWorks.com : Ford Forums - View Single Post

Prochrgd1 · 03-26-2002, 02:07 PM

I'm starting my first engine buildup this weekend & have a few question's about these ARP Head Studs I bought. First off, ARP recommends only hand tightening the studs into the block. Do I oil the threads that are going into the block? If so, what about the studs that are going into the water passages? Will the thread sealant "set-up" if I thread oiled studs through the sealant? The last thing I want to do is tear back into the engine to replace head gaskets after all the time & money I've put into this so far. Many thanks to those who reply.
Jake

All forged & Procharged 94 Cobra

03-26-2002, 02:07 PM	#1
Prochrgd1 Registered Member Join Date: Mar 2002 Location: Lansing Posts: 2	ARP Head Stud install I'm starting my first engine buildup this weekend & have a few question's about these ARP Head Studs I bought. First off, ARP recommends only hand tightening the studs into the block. Do I oil the threads that are going into the block? If so, what about the studs that are going into the water passages? Will the thread sealant "set-up" if I thread oiled studs through the sealant? The last thing I want to do is tear back into the engine to replace head gaskets after all the time & money I've put into this so far. Many thanks to those who reply. Jake All forged & Procharged 94 Cobra