MustangWorks.com : Ford Forums - View Single Post

scale · 04-03-2002, 10:27 AM

I have my stock throttle body and egr spacer off of my car. Does anyone have any recommendations on polishing them? I would by a polished one but most are a bit more than i want to pay. I think the stock one is 60mm and i wouldnt be gaining any performance if i went up to a 65 or 70mm on a stock intake. I have a polished stock intake and would like the TB and EGR to match it....come to think of it, i would have to polish the air bypass valve housing as well. I am just not sure the best way to go about getting started at that. Any ideas?

04-03-2002, 10:27 AM	#1
scale Registered Member Join Date: Mar 2000 Location: minneapolis, mn Posts: 158	polishing stock parts? I have my stock throttle body and egr spacer off of my car. Does anyone have any recommendations on polishing them? I would by a polished one but most are a bit more than i want to pay. I think the stock one is 60mm and i wouldnt be gaining any performance if i went up to a 65 or 70mm on a stock intake. I have a polished stock intake and would like the TB and EGR to match it....come to think of it, i would have to polish the air bypass valve housing as well. I am just not sure the best way to go about getting started at that. Any ideas? __________________ 1991 LX coupe,AOD, red, 80k, K&N, MAC cat back, MAC off-road X, Autometer Gauges, BBK Ceramic unequals, fully polished upper intake, fuel rails, and egr, working on installing.....MM full length subs, H&R sport springs, MM Lower control arms, MM caster camber plates, bilstein shocks, struts.