MustangWorks.com : Ford Forums - View Single Post

red82gt · 05-28-2001, 03:03 PM

I'd just de-burr the spot on the piston to make sure you don't get a hot spot, they're pretty tough (yours are forged, right?).

------------------
GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!

05-28-2001, 03:03 PM	#2
red82gt Sober voice of Reason Join Date: Nov 1998 Location: Kelowna, B.C., Canada Posts: 1,514	I'd just de-burr the spot on the piston to make sure you don't get a hot spot, they're pretty tough (yours are forged, right?). ------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty!