MustangWorks.com : Ford Forums - View Single Post

PKRWUD · 08-11-2002, 01:59 AM

I may have some bad news for you. If you installed a 5spd ECM into your car, and didn't disconnect the wire at pin 30 (in the 60 pin ECM connector), you are frying your ECM, and have possibly damaged it allready. You need to unplug the 60 pin connector from the ECM, turn the key on, and check for voltage at pin 30.

I will be around tomorrow to help you if you need it.

Take care,
~Chris

08-11-2002, 01:59 AM	#21
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	I may have some bad news for you. If you installed a 5spd ECM into your car, and didn't disconnect the wire at pin 30 (in the 60 pin ECM connector), you are frying your ECM, and have possibly damaged it allready. You need to unplug the 60 pin connector from the ECM, turn the key on, and check for voltage at pin 30. I will be around tomorrow to help you if you need it. Take care, ~Chris __________________ Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local RED & WHITE!