MustangWorks.com : Ford Forums - View Single Post

08-21-2002, 01:15 PM

Hey all,

I am thinking about building a mild 302 and was wondering if this would be a good combo, and how much HP/TQ might be expected from it

Specs:

Intake: Edelbrock Performer
Heads: Edelbrock Performer (1.90 or 2.02??)
Cam: Lift: .448/.472 Duration:204*/214*
Carb: Holly 4160 600 cfm w/2" spacer
Headers: What size?

And i was planning on doing Garage Port and Polish on the heads and intake

Any Suggestions on combo? Also is that a good cam, if not what would be a good lift and duration for this combo? Would it be fine to use Hypernetic Pistons or would forged be better (Engine is on a tight budget)

Thank you for any help

steven

PS I was going to get a junker engine to get all the bolts and other EQ i would need, is that ok for this mild of an engine?

08-21-2002, 01:15 PM	#1
Young_Pony Guest Posts: n/a	New Engine Build Help Hey all, I am thinking about building a mild 302 and was wondering if this would be a good combo, and how much HP/TQ might be expected from it Specs: Intake: Edelbrock Performer Heads: Edelbrock Performer (1.90 or 2.02??) Cam: Lift: .448/.472 Duration:204/214 Carb: Holly 4160 600 cfm w/2" spacer Headers: What size? And i was planning on doing Garage Port and Polish on the heads and intake Any Suggestions on combo? Also is that a good cam, if not what would be a good lift and duration for this combo? Would it be fine to use Hypernetic Pistons or would forged be better (Engine is on a tight budget) Thank you for any help steven PS I was going to get a junker engine to get all the bolts and other EQ i would need, is that ok for this mild of an engine?