Hey guys
I have a new problem. I got a small torch and I tried to get the nut off the bolt from the header. I thought I cracked it off and I ended up removingt the entire stud from the headers. Its not a big problem but I just can't find the right size bolt to put back through there. The threads are fine so that isn't the problem. I'm thinking if I can't get the right size, I will just put a smaller bolt through the hole, put a nut on the end and tighten it as much as I can and keep checking it for a few weeks.
If you have any thoughts or if you know the right size bolt, please help me out. Now it is going to go on to a third day but I have to finish it tomorrow.
|