MustangWorks.com : Ford Forums - View Single Post

RPM427 · 08-27-2002, 11:42 AM

I have been driving my car around for a day or so after I just replaced my clutch with a centerforce dual friction. The clutch pedal is very stiff, much stiffer then I thought it would be. It also feels like it is binding and sticking for a moment. It feels like the throwout bearing is binding. It came pre-lubed and the package said not to add anymore lube. I did not put anything on the bearing retainer, should I have? Can I put some grease on the retainer without removing the tranny agian?

08-27-2002, 11:42 AM	#1
RPM427 Registered Member Join Date: Aug 2001 Location: Huntington NY Posts: 573	Need advice on throwout bearing I have been driving my car around for a day or so after I just replaced my clutch with a centerforce dual friction. The clutch pedal is very stiff, much stiffer then I thought it would be. It also feels like it is binding and sticking for a moment. It feels like the throwout bearing is binding. It came pre-lubed and the package said not to add anymore lube. I did not put anything on the bearing retainer, should I have? Can I put some grease on the retainer without removing the tranny agian? __________________ -1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out!