Quote:
Originally posted by Myke_y2k:
Yea, you have to remove the roll pin and slide the shifter base off. Just use a punch to tap it through and pull the base off, it might be a little snug but it will come off. There willalso be a bearing and spring at the bottom of the base. Aslo you will need to shift the top plate over to left (when facing trans from front to back) to slide it off.
|
Couldn't have said it better, but rememeber when putting it back together to make sure the pin is in the shaft smoothly not sticking out on either side or it will hang up. You should go ahead and chage the rear seal to the tranny while it's out.
------------------
Check Out My Site 91GT,Holley SysteMAX II Kit-Heads 2.02" x 1.60" port matched to a 1262,Anderson N-61,24#,76mm C&L,Full MAC exhaust 1-5/8" Long tubes,2-1/2" O.R H-Pipe,2 1/2" cat back, No A/C or PS or emissions, 12" K&N Filter,RNH PERFORMANCE Ram Air,Ron Davis Radiator,Full Suspension,S&W 8pt "X" brace,JAZ seats,3:73's,Welds..etc,4:30's and 31 splines coming very soon!