MustangWorks.com : Ford Forums - View Single Post

NOphonyponys · 06-13-2001, 02:31 PM

Looking for best known combos! I need the ultimate stroker package that is a availble. Just imagine... if you had $6000 in your hand, what motor would you drop into YOUR Stang??!! I want the strongest wheel pullin', head jerkin', tire smokin', MONSTER I can drop into my 94 GT.
Here's my current setup:
324.5RWHP+334RWFTLBS
* Anderson STAGE 2 ported Edelbrock Performer intake (~285CFM)
* Anderson STAGE 2 TFS Heads (283CFM INT/179CFM EXT)
* Pullys
* MSD 6AL + MSD coil
* 75mm BBK Throttle Body
* 80mm Grenatelli MAF
* MAC Cold-Air induction
* 24lb injectors
* Anderson B2 cam
* Anderson PMS computer (tuned by Anderson)
* 1.6 full roller rockers
* MAC H-Pipe
* No cats w/Hooker mufflers
* Tremec 3550
* Alum. Driveshaft
* 3.73 gears w/stock axles
* In-tank 255GPH BBK fuel pump

Probably a few other things I can't recall right now... but the ONE thing you DON'T SEE above is a modified botttom end. Unfortunately, its a bone-stock bottom end! This is where I need everyone's assistance...

Any suggested web pages I could check out, suggested engine builders, or any other advise is welcome! PLEASE HELP! I need to get this damn car into the 11's!

Thanks again guys and gals!

------------------
ONLY 325 RWHP??? DAMN...

06-13-2001, 02:31 PM	#1
NOphonyponys Registered Member Join Date: Jun 2001 Posts: 11	Looking for combo suggestions... Looking for best known combos! I need the ultimate stroker package that is a availble. Just imagine... if you had $6000 in your hand, what motor would you drop into YOUR Stang??!! I want the strongest wheel pullin', head jerkin', tire smokin', MONSTER I can drop into my 94 GT. Here's my current setup: 324.5RWHP+334RWFTLBS * Anderson STAGE 2 ported Edelbrock Performer intake (~285CFM) * Anderson STAGE 2 TFS Heads (283CFM INT/179CFM EXT) * Pullys * MSD 6AL + MSD coil * 75mm BBK Throttle Body * 80mm Grenatelli MAF * MAC Cold-Air induction * 24lb injectors * Anderson B2 cam * Anderson PMS computer (tuned by Anderson) * 1.6 full roller rockers * MAC H-Pipe * No cats w/Hooker mufflers * Tremec 3550 * Alum. Driveshaft * 3.73 gears w/stock axles * In-tank 255GPH BBK fuel pump Probably a few other things I can't recall right now... but the ONE thing you DON'T SEE above is a modified botttom end. Unfortunately, its a bone-stock bottom end! This is where I need everyone's assistance... Any suggested web pages I could check out, suggested engine builders, or any other advise is welcome! PLEASE HELP! I need to get this damn car into the 11's! Thanks again guys and gals! ------------------ ONLY 325 RWHP??? DAMN...