I'm using the stock E7TE heads on my car right now. My car is surely a low 13 second car if not high 12's since the insatllation of the 3.73 gears, King Cobra clutch and traction lock rebuild.
I ported the heads myself and shaved them .030 at work. Then I took them to a shop to have the valves done and a pressure test to check for cracks. After all that I have $150 wrapped up in these heads. You just can't get a much better bang for the buck if you can do most of the work yourself.
But you could also spend $400 for a set of CNC ported stockers with valves and springs from a place in Michigan. They're supposed to flow pretty good too. I just wish I could remember the name of the company. Anyone have any Ideas? I think the name began with a G. Not sure though.
------------------
Too much to list. Best ET on the car so far with stock 2.73 gears - 13.73@102mph
Indiana Stangers Association
Buy your parts here
ICQ# 42269241