View Single Post
Old 11-18-2002, 02:35 PM   #1
MustangGT1990
Registered Member
 
Join Date: Mar 2002
Location: Oliver Springs, TN
Posts: 31
Default Electrical Problem

Ok folks, here is my situation. 90 model GT with stock distributor and coil. I have no fire to the plug wires. I do have fire to the distributor. I pulled the coil wire off of the distributor and turned the motor over and I have fire. But when I pull a plug wire off I do not have fire. The distributor is turning. I tested the TFI module and everything checked out perfect. So, I went ahead and tried a different one and nothing changed. I tested the coil and it also tested fine. The relay also checked out. I have power to everything lights, radio, fuel pump, injector harness, etc.... I checked the voltages coming through the TFI harness and they all showed good. Is it possible I have a problem between the TFI harness and the computer? Or maybe a problem with the stator in the distributor? Has anyone had a problem like this before? The motor was running fine, I cut the key off and have had nothing since.

Thanks in advance.
__________________
1990 Mustang GT 25th Anniversary Edition, 5 speed, 5.0 bored .030" over, FRPP 65mm throttle body, FRPP 1.6 roller rockers, 70 mm MAF, Compcams XE264HR, FRPP Aluminum driveshaft, FRPP Heavy duty clutch, BBK offroad H-pipe, Dual-chamber Flows, Energy Suspension engine and tranny mounts
MustangGT1990 is offline   Reply With Quote