MustangWorks.com : Ford Forums - View Single Post - Where can I run a jumper to the fuel pump?

Coolbreeze · 04-22-2003, 07:59 PM

Make sure you hooked up the EEC ground. It is on the dirver side and had a plug that has a wire that is grounded to the body. I had the same probelm when I re-wired my 86 with 89 harnesses. The plug was open(the other end was missing) and I couldn't remember what it was for. After troubleshooting I cut the plug off and ground the end to the body.

04-22-2003, 07:59 PM	#2
Coolbreeze Registered Member Join Date: Oct 2000 Location: ~Columbus~GA~31909~ Posts: 156	Make sure you hooked up the EEC ground. It is on the dirver side and had a plug that has a wire that is grounded to the body. I had the same probelm when I re-wired my 86 with 89 harnesses. The plug was open(the other end was missing) and I couldn't remember what it was for. After troubleshooting I cut the plug off and ground the end to the body. __________________ Mike Blown~AOD'ed~331~ T-top~ 86GT Check out car on my page here ------ > ~~My 86GT T-top ~~