MustangWorks.com : Ford Forums - View Single Post - t-fitting for 2 oil pressure sending units in stock location

GhettoPop · 08-21-2005, 11:40 PM

i replaced my stock oil pressure sending unit, which is located next to the oil filter, with a new autometer unit and electric gauge. works great but i want to get the old stock gauge working again. i assume i need some type of t-fitting to get both sending units on there. is this the only way to do it? will both units/gauges read accuratly? and most importantly, does any one know the exact size of the fitting i need?

08-21-2005, 11:40 PM	#1
GhettoPop Gimme a Drink! Join Date: Dec 2002 Location: NYC Posts: 694	t-fitting for 2 oil pressure sending units in stock location i replaced my stock oil pressure sending unit, which is located next to the oil filter, with a new autometer unit and electric gauge. works great but i want to get the old stock gauge working again. i assume i need some type of t-fitting to get both sending units on there. is this the only way to do it? will both units/gauges read accuratly? and most importantly, does any one know the exact size of the fitting i need? __________________ 1990 GT,stock T-5,K&N w/o air silencer,March underdrives,FMS wires,timing@14*,PA Perf 130amp alt,Steeda Tri-Ax Shifter,Steeda adj quadrant/clutch cable/firewall adj,Centerforce II clutch,o/r x-pipe,Magnaflow SS catback,g-load brace, subframes,Bilstein struts/shocks,Autometer gauges, 136k and running strong!