Dan
Quote:
Originally Posted by 1979bruiser
i do know that this is a street strip car and i had planed a 3000-3500 stall speed
What diameter?
as for the c/r i can only give you static and no i dont plan to run straight pump gas , at a min 50/50 w/ race fuel as this will be driven fair weather only.
How far do you plan to go on that 50/50 mix?
What happens when you run out?
How big is the gas-tank?
What kind of gas milage do you expect to get with this S/S combo?
im not sure what to tell you for the compression, only what i have i have been told.
With 60cc heads you do have 10.5!!!
and w/o a cam i can not get cranking pressure.
What does it crank now?
total chamber volume is 66.50 w/ the piston releifs if that is no help than i understand, and thanks for the help w/ my post.
dan
|
Ok - So put the same cam in it that I recomended for Brian or use the 51012 & have it custom ground on a 106 LSA and put it in on a 100 ICL
When you check the heads out be sure they have the good valve springs that have at least 135 LBS closed and 175 LBS open. I use Isky 8005-A springs for these HYD Roller cams set the height at 1.9
Denny@JDS Induction Products