Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-18-2001, 11:32 AM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Knoxville
Posts: 20
|
crane 2030 cam
I need a small cam. I am currently having the engine rebuilt stock except for the mods listed below, and because of the 3.08 gear and the fact that it is my only car I don't want a lopey cam. But I want something that will give it a little rumble. I hear the crane 2031 is slower than the stock cam, and crane recommended the 2030 to me as it is a little bigger than the 2031. The 2030's specs are - Duration: 216/220, Lift: .500/.512, and 112 sep. angle. Has anyone used this cam or do you know where I can find a review on it? Should I leave the stock cam in it? Thanks
__________________
1985 Mustang GT Edelbrock Performer intake, Edelbrock 600 carb, 9mm FMS wires, 15^ timing, no smog pump, 8.8 w/3.08 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| MSD or CRANE | Scrapla | Windsor Power | 6 | 05-23-2004 07:31 PM |
| What cam? Crane, Compcam or trickflow | homeroV8 | Windsor Power | 6 | 11-25-2002 08:32 AM |
| crane cam dyno results are in ,kind of? | 46stang | Modular Madness | 5 | 12-04-2001 08:58 PM |
| Crane Cams... | MustangDanny | Windsor Power | 5 | 12-01-2001 09:34 PM |
| Crane 2031 cam and Edelbrock intakes on, impressions..... | 93CobraR | Windsor Power | 4 | 05-23-2001 11:53 AM |