Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-27-2001, 09:02 PM
|
#1 |
|
Registered Member
Join Date: Mar 2001
Location: lafayette IN USA
Posts: 48
|
n/a carb intake? long sorry
Ok heres my new combo: Dss 396 short block with steel crank and eagle esp rods expecting at least 10.5.1 compression, ported and flowed edelbrock preformer heads shaved .030 with 2.02 intake valves and k-motion double valve springs with 180# seat pressure and titianium retainers and locks,crane ultra lite solid roller lifters riding on a reduced radius cam that is still up in the air on exact grind but power from2500 up,bbk 1 3/4 inch longtube headers(think i should go with 2"?)carb will probably be a 1050cfm king demon.I was thinking of a ported victor jr but am excitedly open to any suggestions.I plan on shift points being around 7800.
__________________
91GT Flowmaster 2 chambers,off road H pipe,mac equalength headers,F303 cam,high lift valve springs ,svo 1.6 roller rockers,19*timing,410's,BBK cold air kit,hurst shifter, Pullys,World class T5 MSD 6al box. Ran 13.5@101 with stock headers and air box. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cobra Intake? | 95mustanggt | Windsor Power | 5 | 10-01-2002 09:55 AM |
| Project 5.4L! (long) | Mustang92 | Modular Madness | 14 | 12-19-2001 04:47 PM |
| What Carb And Intake Should I Use???? | vande97 | Windsor Power | 8 | 11-27-2001 02:12 AM |
| demon carb on 289??? | 69roadrunner | Modular Madness | 1 | 07-21-2001 07:42 PM |
| BBK one-piece flange or MAC individual flange long tube headers. | Fox Body | Windsor Power | 10 | 04-03-2001 04:25 PM |