Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
07-27-2002, 12:59 AM
|
#1 |
|
Registered Member
Join Date: Nov 2000
Location: Maple Ridge B.C. Canada, The Best Place In The World
Posts: 871
|
Going To Attempt A MAF To SD, And SD To MAF Conversion... Please Help
I am going to attempt to swap out my speed density system, and put it in my buddys MAF car, and his maf into my car.
are there any good sites that explain how to do this? who will gain power, and how much? Thank You
__________________
1984 Bronco II, 36" Michelin Military Tires, 95 EFI 5.0, NP435 Tranny, NP208 Doubler, NP205 Transfer Case, Fill Size Solid Dana 44 Front End, WH Progressive Rate Rock Crawling Coils, Bronco 8.8 Rear, Skyjacker Softride Leafs, 5.13 Gears, Detroit Locker. Final Crawl Ratio Of 175:1 88 GT Best 60ft. 2.181 Best ET 14.350 Best MPH 98.01 ~WRECKED!!!!~ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 5 lug conversion | stanger9219 | Windsor Power | 2 | 02-25-2004 11:31 PM |
| What all do you need to do rear disc conversion w/ SN95 Parts | KG88GT | Windsor Power | 1 | 07-29-2003 01:45 PM |
| questions about maf conversion | spankaveli | Windsor Power | 10 | 10-19-2002 02:46 PM |
| 5 to 4 lug conversion | mike_navigator | Blue Oval Lounge | 7 | 08-14-2002 11:17 PM |
| mass air 87GT conversion | greydan | Windsor Power | 3 | 01-02-2002 07:57 PM |