Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-07-2003, 03:33 PM
|
#1 |
|
Registered Member
Join Date: Apr 2002
Location: Fordland
Posts: 117
|
Glass Beading
Well, project "stocker" will be going into full swing soon with the motor arriving next week, and the next step is polishing the intake, and other parts. My question is:
I know that most recommend sanding the casting to get to the bare aluminum, but I've got access to a glass bead blaster at work, and I'm wondering if this is safe for the intake. Don't want to compromise the integrity of the piece. I know it works great on golf putters!  Thanks, JD
__________________
'88 Speed Density LX 1998 Explorer motor 1.7 Roller Rockers GT-40 lower ported & polished Cobra upper intake MAC CAI Aluminum Pullies FRPP P-Shortys Cop car cam (to insult) Competition Engineering F/R adjustables Flowmasters New black carpet and... '84 Racin' Tempo seats! Cars' best run in 2002 with stock 150,000 mile 302 with pullies, exhaust and roller rockers only... 13.27 at 101.5 mph |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear siderfin/full quarter glass swap??? | 429mustang | Blue Oval Lounge | 6 | 03-26-2003 10:26 PM |
| Glass beading? | chickendreamer | Windsor Power | 2 | 11-15-2002 01:39 PM |
| Quarter Glass Trim... HELP! | Bad89stang | Windsor Power | 7 | 12-08-2001 03:07 AM |
| Glass Top | lx mike | Blue Oval Lounge | 4 | 02-15-2001 03:01 PM |
| 68 convertable side glass | daleford | Classic Mustangs | 0 | 07-07-2000 12:35 PM |