Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-22-2004, 09:57 PM
|
#1 |
|
Registered Member
Join Date: Jun 2003
Posts: 1
|
clutch?
Well, when i took my car out today I noticed that my rpms would jump up and my speed wouldn't move much at all so I think I'm gonna have to replace the clutch. What is a good clutch to go with for my mods and a stock tranny and rear end and what other parts should I replace while I have it apart?
__________________
'95 GT Edelbrock performer intake, Edelbrock Aluminum heads, crane cams roller rockers, 65mm T-body, pro 5.0 shifter, 1 5/8 ford racing headers, borla cat-back, all new suspension(steeda springs, toxico shocks, etc), k&n air filter, removed air silencer, fms 9mm spark plug wires, kirban afpr, frpp 24# injectors, 75mm pro-m bullett maf |
|
|
|
05-22-2004, 10:29 PM
|
#2 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
Centerforce Dual Friction is a good chioce for your setup. You should also replace the throwout bearing and refill your tranny with some Redline ATF.
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |