Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-11-2004, 08:49 PM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Posts: 167
|
are my 30#ers too big for my set up?
i was talking to a kid who knows about mustangs after building and owning 2. he drove my car and said that it felt strong, however when i told him it had 30# injectors, he said i should switch them to 24#'s. what do you think? he thinks i can add 20-30 horses from doing so but i would have to change my MAF calibration. does this sound right? if i do that, how much can i expect to spend in labor and parts if a shop did it? thanks
jim PS i was also told that a burnt chip could help about 20-30 HP or so. is this true? i thought you could do the same with timing and fuel pressure. thanks jim
__________________
OLD CAR-89 lx convt- Flowtech II headers, H-pipe, 2 1/2 "flowmasters- pulleys- 3.73's, ripper shifter- ram air- Best 1/4 mile time- a measley 14.2 at 98.6  PRESENT CAR- 90 LX BBK long tubes, h-pipe with cats, flowmasters. 3.55's holley systemax II kit- 70 mm TB 30#injectors, jacobs ignition, black magic fan, 180 thermostat, 75 shot of NOS- NITTO DR'S STREET TIRE BEST RUNS 1/4 mile13.2 @112 w/ NOS 2.17 60' 13.5 @103 2.1 60' *new time with Dr's 12.8 at 111 w/ 75 shot |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| incon amd 30#ers??? | Maverick_1099 | Windsor Power | 6 | 02-28-2001 09:07 AM |