Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-17-2005, 05:45 PM
|
#1 |
|
Registered Member
Join Date: Jun 2002
Location: manassas, va
Posts: 186
|
starting woes
Start the motor in sig up. runs and drives fine. water temp is 180-190. New 92 mustang starter(high torque). But after running and shutting off, it wont crank over but just a little bit. Battery/Alternator is good.
It will cool down and start up later. Long tube headers. Didnt have this before with these headers, but I did put exhaust wrap over the headers to try to lower under hood temp. Now it wont crank after running.
__________________
1983 mustang, 393 cubic inch stroker small block, victor jr heads and intake, gold race 1.6 roller rockers. comp cam 304, 244@ .050. .576" hydralic retro roller cam,lunati rods. block was o-ringed,10:1 forged pistons, speed pro fit fit rings, clevite bearings,msd distributor and igniton,be cool huge radiator, black lite electric fan, march underdrive pulleys, mildon deep sump oil pan, mac 1 3.4" long tube headers, 3" dr gas x-pipe and mac exhaust,ARP bolts. car weighs 2900 lbs w/out driver, sub frames, weld wheels, mickey thompson sportsman pro 26 x 10.5 x 15's,#8 fuel line steel braided |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| hard starting | JMG | Small Ponies | 2 | 01-22-2006 12:09 PM |
| grr...starting problems..any ideas? | Frankenstang65 | Classic Mustangs | 16 | 07-07-2003 09:50 AM |
| problems starting car, please help | apowers2k | Modular Madness | 1 | 11-08-2002 12:17 PM |
| Please Help !! Engine Starting Problem | Jayskee | Windsor Power | 1 | 07-23-2002 06:08 PM |
| starting problems | 92Convertible | Windsor Power | 1 | 03-10-2002 06:22 PM |