Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-28-2007, 06:51 PM
|
#1 |
|
Registered Member
Join Date: Jan 2007
Posts: 12
|
Valves
Well peeps I just put together my motor...302 GT40P heads that has been ported all the way open too 260cfm...1.7 rockers,+trick flow stage one cam .499/.510 lift,24lbs injec,73mm mass air meter,trick flow track heat intake,70mm throttle body...The only thing I forgot to do was check the valve to piston clearance...This is a stock botom end so wish me good luck...Bythe way i havent fire the car yet im still waiting to see if anyone no if this set up will be okay...
__________________
hrdroc-.600 lift springs GT40P heads ported all the way out,1.6 ratio roller rockers,24lb injectors,70mm throttle body,under pulley's,cobra intake port match to the head,trick flow stage 1 cam .499/.510 lift,cold air intake,73mm mass air meter,adj fuel pressure regulator. stock bottom end et street slicks- 13.50@104.99 best 60ft. 1.720 3.73 gears reg street tires- 14.89@101.25 best 60ft. 2.090 3.08 gears |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| valves | jhun66stang | Classic Mustangs | 17 | 11-12-2006 06:21 PM |
| New Valves | Florida Stang | Windsor Power | 2 | 03-13-2002 08:22 AM |
| Help with valves!!!!!!! | Stang Runner | Windsor Power | 3 | 09-16-2001 12:33 PM |
| Help with valves!!!!!!! | Stang Runner | Windsor Power | 0 | 09-15-2001 04:11 PM |
| Valves | Patrick Boetticher | Windsor Power | 0 | 03-05-2001 10:31 PM |