Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-30-2001, 03:10 AM
|
#1 |
|
Registered Member
Join Date: Oct 1998
Location: Dallas, TX
Posts: 261
|
Car is now backfiring after intake install
I just installed a 94 Cobra lower and 97 Explorer upper in my 1990GT. It all went pretty smooth except I moved the act sensor to the intake inlet hose since I didn't have a tap. I think when I put the distributor back in I might have moved it a bit. I don't see any leaks anywhere. I do smell alot of gas too, any ideas?
Thanks, Leo ------------------ 1990GT 5.0 302, T-5, 3.73's, K&n Air filter, Dynomax Super Turbo Exhaust, Hypertech Chip, MSD 6A Ignition, RAM Clutch, Motorsport 3 core, Offroad H-pipe. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Edelbrock RPM intake install problems | jruppert | Windsor Power | 4 | 03-04-2004 05:05 PM |
| upper intake and egr spacer install..... | scale | Windsor Power | 3 | 08-18-2002 11:37 PM |
| Problems with 1.7 rockers and cobra intake install (read) | Ian'sGT's | Windsor Power | 12 | 04-11-2001 08:22 PM |
| new coolant leak after intake install | fiveohpatrol | Windsor Power | 15 | 03-04-2001 09:15 PM |
| explorer intake here, a few Q's on install | fiveohpatrol | Windsor Power | 12 | 02-28-2001 09:40 PM |