Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-14-2002, 01:20 PM
|
#1 |
|
Registered Member
Join Date: Jun 2001
Location: West Melbourne, FL, USA
Posts: 237
|
Checking U-Joints?
Hey! Trying to see how it would be best to check u-joints for 5.0 T-5, 8.8 rear equipped Mustangs. I heard a clunking noise out of my car's rear when decelerating. I tsounded definately like from the rear & not my tranny, but I wnat ot check it out....should there by ANY play in the driveshaft? Thanks for any/all advice! later!
__________________
93Cobra#3974, 114K miles 3.55's, flo's, pullies, C&L 1/4: 13.985 60': 2.088 (street tires) MPH: 99.58 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ball Joints | cschulzy | Windsor Power | 4 | 03-23-2003 01:18 PM |
| A-arm bushings and Ball joints | glxstang | Windsor Power | 3 | 07-22-2002 01:22 PM |
| Ball Joints | gray ghost86 | Windsor Power | 4 | 06-06-2002 11:08 AM |
| separating ball joints and tie rod ends...best way? | 82 GT | Windsor Power | 8 | 02-22-2002 03:56 PM |
| putting 94-95 ball joints on to 89 a-arms | John Cummins | Windsor Power | 0 | 06-18-2001 07:28 PM |