

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#1 |
Registered Member
Join Date: Mar 2002
Location: Austin, TX
Posts: 18
|
![]() i'm running a low 12-sec mod motor and i plan on running 2 blow-off valves (1 before and 1 after the intercooler) running approx. 10psi.. should i get 2 vortechs or some other brand like blitz?
what are your experiences with any of the brands out there? thanks
__________________
00' GT, vortech sq-trim, full exhaust, 90mm maf, 42#r's, megabyte jr.'s, custom diablo chip.. + too much more too list.. run's high 11's Last edited by coolguy620; 08-11-2002 at 06:47 PM.. |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Jun 1999
Location: Walker, MI, USA
Posts: 1,202
|
![]() well I think they are all about the same myself Some might last longer.... But a OEM eclips one might be fine for you even.
__________________
Engine: steel mounts, Under drive pulleys, K&N, GT-40 Intake ported Lower, No power steering, No A/C, Mac cold intake, 65MM TB, 255 Fuel pump, 24's, AFR 165 58cc, Rocker Arms 1.7with the stock Cam, 1 5/8 short headers, offRoad X-pipe Drive Train: 3.55, T-5 with a Pro 5.0 shifter 12.656@107.71MPH See It at www.T-racing.com/mustang.htm |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Air by pass valve question. | Jaegermeister2k | Power Adders | 21 | 05-06-2005 09:40 PM |
valve problem | pearlgt40 306 | Windsor Power | 3 | 07-05-2003 01:21 AM |
can i use a blow off valve | Brian88 | Windsor Power | 3 | 01-26-2002 02:39 PM |
Proportioning Valve | MidniteWrider | Classic Mustangs | 1 | 07-11-2001 09:14 AM |
PCV Valve what the ?@#$@#$@$ | Chevyguy | Windsor Power | 3 | 04-11-2001 08:01 PM |