Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-23-2003, 02:08 PM
|
#1 |
|
Registered Member
Join Date: Aug 2001
Location: Huntington NY
Posts: 573
|
Clutch help needed!!
I start my car thismorning and i hear a tapping noise, and it goes away when I push in the clutch. So I take off the cover on the bellhousing, where the cable goes into it and take a look. Everything looked ok, so i start the car and take a look. The throw-out arm it moving all over the place, and was hitting the cover. I can also see the clutch itself moving as well. Is it possible the bolts holding the clutch on the flywheel came lose? Could it be the throwout bearing? What are some possible cuases of this?
__________________
-1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| Advice needed for a clutch replacement in a 2000 GT | GLDNPNY | Modular Madness | 2 | 03-06-2003 10:07 AM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |
| Clutch help needed. | 96cobra89Lx306 | Modular Madness | 1 | 07-10-2000 09:03 PM |