Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-11-2003, 11:50 AM
|
#1 |
|
Registered Member
Join Date: Jan 2000
Location: Mount Joy, PA , U.S.
Posts: 198
|
ROller Rockers How tight
I'm putting 1.72 roller rockers on my 5.0 and I need to know how far do I torque them down.
0 lash is when the rocker is just touching both the rod and the valve stem, right And then do I tighten them down 1/4 turn Because I was doing this and the valves where begining to open. Should my lifters compress, because some of them do not. Thanks |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roller rockers for stock heads | QuantumMotorsports | Windsor Power | 1 | 07-14-2003 03:15 PM |
| Roller Rockers, bad? | HiFlow5 0 | Windsor Power | 1 | 04-14-2002 01:35 PM |
| roller rockers | bobtodd | Windsor Power | 4 | 04-07-2002 01:34 PM |
| reg rockers or roller rockers?? | Chevysucks | Windsor Power | 1 | 12-05-2001 08:17 PM |
| Valve Springs & Roller Rockers | StreetStang37 | Windsor Power | 4 | 04-17-2001 03:54 AM |