Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-12-2002, 12:22 PM
|
#1 |
|
Guest
Posts: n/a
|
cutt outs?
Do any of you guys have cutt out in your exuahst to make it have more of a rumble. I was thinking of doing it because it sounds realy good and loud. but the two fireinds of mine that did it have the cutts in thier stock exaust. and i'm wondering if it will be too much with the exauhst i have???
|
|
|
03-12-2002, 01:14 PM
|
#2 |
|
Registered Member
Join Date: Nov 2001
Location: germantown MD
Posts: 283
|
Get turndowns or dumps. That will make it a little louder.
__________________
85 GT 4bbl roller cam 2 ch. Flowmasters, O/R H-pipe Performer intake and carb milodon water pump, FMS 9mm wires, aluminum driveshaft, king cobra clutch |
|
|
|
03-12-2002, 06:16 PM
|
#3 |
|
Guest
Posts: n/a
|
what r dumps?
|
|
|
|
03-12-2002, 06:44 PM
|
#4 |
|
Registered Member
Join Date: Apr 2001
Location: Staging lane
Posts: 4,337
|
My pipes are dumped right before the back axle.......Its were the pipes point towards the ground.
Pros>>They sound deep and good..and you can clean your shop floor just by revving up your car. Cons>>They blow dirt all over you car sometimes and at highway speeds the droaning sound can get to you after a while.
__________________
92' LX-Big brakes, Lots and lots of suspension, GT40X heads, Ported cobra intake, stock cam, Vortech SC trim. 00' Lightning-Stock 88'CRX-13 second ego killer |
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rear tail light black outs | my9250GT | Appearance & Detailing | 3 | 12-30-2003 11:37 AM |
| street tire burnouts | mak375 | Stang Stories | 19 | 04-29-2003 11:30 AM |
| Exhaust cut outs | mlambrecht82 | Modular Madness | 4 | 10-19-2002 11:52 AM |
| burn outs | stang_4u2nv | Small Ponies | 3 | 08-09-2002 01:31 AM |