Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-24-2001, 12:57 AM
|
#1 |
|
Registered Member
Join Date: Jul 2001
Location: KY
Posts: 59
|
Cheap flow???
If I bought a new set of untouched twisted wedges, what would you recommend doing to make them flow a little better without spending much money? Multi-angle valve job??? Port matched to intake?? or should I just leave them alone until I'm ready to spend some money? While I'm on the subject of flow, is a 3/8" intake spacer worth installing on the street heat?
__________________
'89 LX 5spd w/ 65k miles Ported stock heads, TFS Stage1 cam, GT-40 intake, 70mm TB, 76mm MAF, MAC headers, Flowmasters, 3.73 gears, Steeda Tri-AX, Mickey ET Streets, Vortech V1-SC, 38# injectors, Crane InterceptorII 7.9's @92mph (traction enhancement devices needed) |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trick Flow intake problems | shacar87 | Windsor Power | 9 | 11-14-2003 05:53 PM |
| Head and intake flow. Something to think about. :) | 5ohCOUPE | Windsor Power | 3 | 03-16-2003 08:52 AM |
| Cheap Cheap Porting Would it work? | vetteeatr | Blue Oval Lounge | 1 | 11-02-2002 10:34 AM |
| Head flow comparison | Mopar1 | Windsor Power | 6 | 07-20-2002 08:03 PM |
| Exhaust Flow Numbers on Heads | 95mustanggt | Windsor Power | 6 | 02-04-2002 11:09 AM |