Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-01-2002, 11:32 PM
|
#1 |
|
Registered Member
Join Date: Mar 2002
Location: Oliver Springs, TN
Posts: 31
|
Question about stock cam specs
I am wondering if anyone has or knows where I can find any info regarding stock cam specs for 87-90 GTs. I know that a few minor changes were made during those years. Ford Racing's website lists the following as "stock specs" for 5.0L HO cams.
Advertised specs are 266 Degrees/266 Degrees duration, 0.444" lift. Does anyone know if this is close? Also, what is the max lift you can run "safely" with stock heads and stock 4 relief pistons?
__________________
1990 Mustang GT 25th Anniversary Edition, 5 speed, 5.0 bored .030" over, FRPP 65mm throttle body, FRPP 1.6 roller rockers, 70 mm MAF, Compcams XE264HR, FRPP Aluminum driveshaft, FRPP Heavy duty clutch, BBK offroad H-pipe, Dual-chamber Flows, Energy Suspension engine and tranny mounts |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stock Air Intake Box Question | ponyboy25 | Windsor Power | 4 | 02-14-2003 07:43 PM |
| Question on stock heads and intake | Yan88gt | Windsor Power | 1 | 06-24-2001 08:13 AM |
| LT's vs. shorties vs. stock headers | jonnyk | Windsor Power | 9 | 01-01-2001 11:28 AM |
| Trophy Stock Intake Question? | RL Wiltshire | Racer's Club House | 7 | 10-20-1999 08:11 PM |
| 2000 Street Stock - the $15,000 question | Tim Miller | Racer's Club House | 4 | 10-20-1999 07:09 PM |