Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-22-2001, 05:09 PM
|
#1 |
|
Registered Member
Join Date: Oct 1999
Location: Murfreesboro, TN
Posts: 123
|
Tremec in '95-Longer Driveshaft
I recently had a Tremec 3550 installed in my '95. Everything seems fine, BUT I have read where the driveshaft needs to be lengthened by 5/8 of an inch. I looked under the car, and sure enough the stock driveshaft is on there, and you can see it is about that far out from the original wear pattern on the yoke. Is this going to hurt anything? I am looking at an aluminium driveshaft, but is it going to be the right length? I know they used the Tremec in the Cobra R, do they have a part number for that driveshaft?
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| is tremec tko compatable with any bellhousing | jruppert | Windsor Power | 4 | 05-05-2003 02:23 PM |
| Longtubes w a Tremec 3550? | fastang | Windsor Power | 2 | 03-15-2001 07:43 PM |
| Tremec Transmission | rtz | Windsor Power | 21 | 02-27-2001 03:02 PM |
| FMS. Driveshaft or Suspension..... | Chris_H | Windsor Power | 5 | 01-06-2001 09:15 PM |
| tremec 3550 swap | 97 Aztec | Modular Madness | 2 | 12-03-1999 09:12 PM |